Port SERVICEACCESS - ARP

Responds on ARP requests

此端口要求安装 PCAP 驱动。

Stimulation

此端口不具备激励能力。

Name

在以下情况下可用

默认值

有效值

Type

Description

网络接口卡

[ONLINE]

string

Used network interface card

Filter in BPF format

‘ether proto \arp’

string

Filter for the ARP protocol. The identifier [IP] that is enclosed in square brackets describes a variable which will be replaced when loading the configuration. [IP] correspond to the value in the port settings. VLAN filtering is applied automatically.

VLAN settings

‘no tagging’

[‘no tagging’, ‘single tagging’]

string

Used VLAN setting

VLAN-VID

1

int

Integer, only used if VLAN tagging is enabled

Receive buffer size

1000

int

Number of messages which can be recorded in the receive buffer (ring buffer)

Automatic data reception on test run

☑

bool

Only operative if on the left for ‘Start’ either ‘Always’ is chosen, or ‘If necessary’ and the port is in use in the test configuration.

Path / file name for the PCAP/PCAPNG output file

Automatic data reception on test run

string

PCAP or PCAPNG file (with absolute path). Recording is done into this file. Leave blank if no recording is desired.

Default source MAC address

‘Default’

string

Default MAC which will be used as source address for ethernet frames, leave Default if the primary adapter MAC address should be used

Default source IP address

‘Default’

string

Default IP which will be used as source address for ethernet frames, leave Default if the primary adapter IP address should be used

VLAN-PCP

0

int

Integer, only used if VLAN tagging is enabled

VLAN-CFI

0

int

Integer, only used if VLAN tagging is enabled

ClearReceiveBuffer

Clears the ecu.test high-level receive buffer. Low-level buffers in the driver are not cleared.

StartReceiving

Starts manual data receiving

Parameterization

Parameter

Name

在以下情况下可用

默认值

有效值

Type

Description

FilterString

‘ether proto \\arp’

string

Filter for the ARP protocol. The identifier [IP] that is enclosed in square brackets describes a variable which will be replaced when loading the configuration. [IP] correspond to the value in the port settings. VLAN filtering is applied automatically.

PcapFileName

string

PCAP or PCAPNG file (with absolute path). Recording is done into this file. Leave blank if no recording is desired.

VlanVid

‘Default’

string

Integer, Default if port setting should be used, only evaluated if VLAN is configured

StopReceiving

Stops data receiving manual